Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Fast, Reliable Kitchen Remodeling Across Corte Madera
A full kitchen remodel in Corte Madera runs $14,000 to $45,000, and small or partial remodels fall between $9,000 and $20,000. The job typically includes demolition, rough-in work for plumbing and electrical, cabinet installation, countertop fabrication and setting, backsplash, and finish plumbing. Corto Madera’s building department reviews every permit package carefully, and work near the marsh often carries additional environmental conditions that can move the schedule. If you want a written price before any work starts, call Bradfording Remodeling at (903) 568-7222.
We know Corte Madera’s housing stock. We know the hillside lots off Tamalpais Drive, the bayside tracts near the marsh, and the mid-century ranches clustered off Redwood Highway. We also know what a permit review will flag in each of those zones before we ever touch a wall. That local knowledge is the difference between a schedule that holds and a kitchen left open for an extra month.
Kitchen Renovation in Corte Madera
Kitchen Renovation in Corte Madera usually means reconfiguring the footprint of a 1960s or 1970s kitchen, replacing the cabinet run, updating the electrical and plumbing rough-in, and upgrading surfaces to materials that hold up to a busy household. In Corte Madera the price for a full renovation runs $14,000 to $45,000, with most mid-sized projects landing in the $20,000 to $30,000 range. The final number depends on cabinet choice, countertop material, and whether any wall changes trigger structural work.
What we see again and again in Corte Madera is a kitchen that was never designed for how a family lives today. The sink faces a wall. There is no island. The refrigerator door swings into the cook. A renovation fixes those problems rather than dressing them up.
Load-Bearing Walls and Permit Timing
Many of the older homes in Corte Madera have kitchens in the center of the house with no exterior wall. The wall between the kitchen and dining room is often load-bearing. When we open up the plans, we check the structural drawings early so the permit review doesn’t stall after demolition. That review happens before we order cabinets, not after the old kitchen is gone.
Scoping a Kitchen Renovation the Right Way
Before we write a price, we walk the job with a plumbing and electrical review. We check the subfloor if the kitchen sits over a garage or crawlspace. We map the vent route. We confirm which walls carry the roof. Then we give you a written price with the scope spelled out, so you know exactly what the number covers. The Garrison Standard requires that in writing before a single tool comes out.
Styles & brands we work with
Cabinet Installation in Corte Madera
Cabinet Installation in Corte Madera runs $4,000 to $13,000 for the full installation, including the demolition and removal of the old cabinet run, rough-in adjustments, setting new cabinets, and leveling the run before countertops are measured. Many Corte Madera homeowners use this as the opportunity to fix an older kitchen that is otherwise functional: new cabinet boxes, new doors, new hardware, and the countertop after that.
We install KraftMaid and Wellborn cabinets on most Corte Madera jobs. The cabinets come with manufacturer specs and a warranty, and our own 365-Day Done Right Promise backs the installation as well. If the cabinet run shifts or a drawer fails inside the first year, we return and correct it at no charge.
When a Refacing Job Makes Sense
If the cabinet boxes are sound and you simply want new doors and drawer fronts, refacing is usually under $13,000 and often closer to $4,000 to $7,000 in Corte Madera. The boxes stay in place, the face frames or doors get switched, and the kitchen gets a new look without moving plumbing or electrical. The downside is that you are locked into the current layout, and any flawed basic cabinet structure stays in place. We’ll tell you when refacing is a smart call and when a full replacement is the better long-term move.
What Adds Cost to the Installation
Soft-close hardware, custom inserts, and matching panels for the dishwasher and refrigerator all add to the final number. Those items are listed in the written price before work starts, so they are never a surprise at the end. In older Corte Madera homes we often need to pack out uneven walls or shim a floor that has moved over 60 years. A level cabinet run matters more than most homeowners expect, especially when the countertop fabricator templates from it.
Why Bradford Remodeling Is Corte Madera’s Preferred Kitchen Remodeling Company
Bradford Remodeling is part of the Garrison Partners family, established in 2004 and held to The Garrison Standard: a written price before any work starts, background-checked and uniformed technicians on every visit, and a live person answering the phone around the clock. Curtis Lane runs our Corte Madera work with the same discipline on every job: the scope is documented, the numbers are in writing, and the site is clean at the end of every day.
Homeowners in Corte Madera call us after getting burned before. They have had crews no-show, change the price at the door, leave the job half-finished. We hear those same stories in Larkspur, Mill Valley, and Kentfield. Our answer is always the same: a written scope, a fixed price, and a signed 365-Day Done Right Promise at the close. No one on our crew walks into your home without a stated schedule for that day.
Call (903) 568-7222 and a live person answers. Not a voicemail, not a queue. If you call at 2 a.m., you get a real person who can help schedule a walkthrough.
Trusted Brands We Service in Corte Madera
We specify materials from a documented roster: KraftMaid and Wellborn cabinetry, Cambria and Caesarstone surfaces, Kohler and Moen fixtures. On projects where a prefab structure is part of the scope, we have worked with Abodu, Cover, and Dvele for panelized and modular components. When homeowners pick those brand names, the specifications are traceable, and the manufacturer warranties sit alongside our own guarantee. Our Corte Madera clients often ask for Cambria quartz or Silestone because both hold up to hard use and clean easily. We keep finish samples in the truck for quick decisions on site.
See the difference
Before
After
Before
After
Before
AfterCommon Kitchen Remodeling Problems We See in Corte Madera Homes
- Removing a load-bearing wall without a structural review. In Corte Madera’s older bayside and hillside homes, many interior walls carry the roof load. Cutting into one without a beam design turns a cabinet swap into an unplanned reframing job that can add thousands to the budget.
- Underestimating marsh-zone and flood-adjacent permit timelines. Properties near the Corte Madera Marsh go through additional environmental review. The permit clock on those jobs often runs longer than homeowners expect, and demolition should not start until the permit is in hand.
- Treating allowances as fixed prices. A Kohler fixture upgrade, a Cambria slab selection, or a KraftMaid custom cabinet line will push the number past the allowance. If the allowance is not written down with clear numbers, that becomes a change order at the end. Our written price includes each allowance as a specific dollar figure.
- Centered kitchens with no exterior wall. Corte Madera has a large stock of mid-century homes where the kitchen sits in the middle of the house. Putting in a bigger window is often impossible. These jobs frequently need skylights or mechanical ventilation rather than a window swap, which changes the scope and the budget.
Pricing for Kitchen Remodeling in Corte Madera, CA
Here are the honest ranges for Corte Madera, with no numbers that move at the door.
| Scope | Typical Price Range |
|---|---|
| Kitchen Remodel | $14,000 – $45,000 |
| Small Kitchen Remodel | $9,000 – $20,000 |
| Cabinet Installation | $4,000 – $13,000 |
| Countertop Installation | $2,000 – $6,500 |
| Backsplash Installation | $800 – $2,500 |
| Kitchen Island Installation | $3,000 – $10,000 |
What moves the price in Corte Madera is structural work, rough-in changes, and permit conditions. A load-bearing wall removal adds framing and an engineer’s sign-off. Marsh-zone and flood-adjacent lots can require additional review. Moving a sink or range across the room adds plumbing and electrical rough-in. The written price we give you covers the scope as scoped. If the scope changes, the change order is a separate, documented line item, not a surprise at the end. Call (903) 568-7222 for a free written estimate.
We Also Serve Cities Near Corte Madera
Our crew serves the surrounding areas including Larkspur, Mill Valley, Kentfield, and San Rafael. If you are in one of those towns, our Kitchen Remodeling team can help with the same written-price discipline and local familiarity. For a closer look at how we work in this specific community, see our page on Kitchen Remodeling in Corte Madera.
Serving Corte Madera, CA - Our Local Coverage Area
We’re based in the Corte Madera area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Kitchen Remodeling in Corte Madera
Yes. Any kitchen remodel in Corte Madera that moves plumbing, electrical, or walls requires a permit with the town’s building department. Typical inspections include the rough-in inspection for electrical and plumbing, a structural inspection if any wall work is done, and a final inspection after finish work. Work near the marsh or in flood-zone-adjacent properties may also involve environmental review before the permit is issued. Bradford Remodeling pulls all permits and schedules every inspection. Call (903) 568-7222 and we can confirm what your specific property will trigger before you commit to anything.
A full kitchen remodel in Corte Madera typically takes 6 to 10 weeks from the first day of demolition to the final punch list. The biggest schedule drivers are permit review time, structural work, and material lead times for cabinets and countertops. A cabinet-only install runs 1 to 2 weeks. A small kitchen remodel often lands around 4 to 6 weeks. We give you a written schedule with the written price, and we update it as inspections pass. Call (903) 568-7222 for an estimate that includes the calendar, not just the dollars.
The big cost drivers in Corte Madera are load-bearing wall work, rough-in relocation, and permit conditions near the marsh or flood zone. A wall removal that requires a new beam and an engineer’s letter adds structural cost. Moving a sink or gas line adds plumbing and electrical rough-in. Marsh-adjacent properties can take longer in review, which adds carrying cost. Materials also matter: a KraftMaid custom cabinet run and a Cambria quartz slab will cost more than stock cabinets and a standard countertop. We list every one of those line items in the written price. Call (903) 568-7222 to go line by line.
Maybe. Many interior walls in Corte Madera’s older bayside and hillside homes are load-bearing, and the wall between the kitchen and dining room is often one of them. You need a structural review before any saw touches that wall. If it is load-bearing, we can still remove it, but it requires a header or beam designed by an engineer, approved by the town, and installed before the wall comes out. That adds cost and a structural inspection. We handle the engineering, the permit, and the framing. Call (903) 568-7222 and we can look at your floor plan and tell you what is likely before you pay for an engineer.
A draw schedule is the written agreement of when payments are due as the project hits specific milestones: permit issued, demolition complete, rough-in passed, cabinets installed, final inspection passed. It protects you from paying for work that has not been done and protects us from floating the entire job. In Corte Madera, where marsh-zone permit timing can stretch the early phase, a clear draw schedule keeps expectations honest on both sides. Every Bradford Remodeling contract includes a draw schedule in writing before work starts. Call (903) 568-7222 and we can walk you through how a draw schedule looks on a kitchen job.
Written by Curtis Lane, Owner at Bradford Remodeling, serving Corte Madera under The Garrison Standard.
