Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
KraftMaid Fence Installation: The Los Angeles Owner’s Guide
KraftMaid fence installation in Los Angeles typically runs $4,130 to $10,620 for a complete install, depending on linear footage, post setting, and gate hardware. We stock KraftMaid-compatible fence components on our trucks and can usually start the job within a few days of your written estimate. Most owners discover the problem the hard way: a gate that drags, a post that leans after a rainstorm, or pickets that split away from the rails the first time the Santa Anas hit.
Which KraftMaid Models This Applies To
Let’s be straight about one thing first: KraftMaid is a cabinet manufacturer. They don’t make fence panels. If you’ve got a fence that was part of a KraftMaid outdoor kitchen or pergola enclosure package, or fencing installed alongside KraftMaid cabinetry in an outdoor living build, the fencing itself is typically a third-party component matched to the KraftMaid aesthetic. What that means for you: the fence posts, rails, and pickets need to be measured against the existing post spacing and rail channel width, not a KraftMaid part number.
The compatibility gotcha we see in Los Angeles: many outdoor kitchen surrounds use 4×4 posts at 6-foot centers with 1×6 pickets and a 2×4 top rail. But some builds step up to 6×6 posts with steel-reinforced post bases for wind load. If you replace with the wrong post dimension, your gate sags within a season. Measure the existing post dimension and the gap between pickets before you buy anything.
On the OEM-vs-aftermarket question: there’s no true KraftMaid OEM fence part to buy. What you’re really deciding is between pressure-treated lumber, cedar, or vinyl routed to match the existing profile. We spec cedar for most Los Angeles replacements because it holds up to UV and dry rot better than untreated pine, and it takes a stain that matches most KraftMaid cabinet finishes we’ve worked around.
Styles & brands we work with
Signs Your KraftMaid Fence Installation Is Failing
- Gate dragging or won’t latch. The hinge post has shifted out of plumb, usually because the post base wasn’t set below the frost line or the concrete footer cracked. Los Angeles clay soil expands and contracts with moisture, and that movement works posts loose over time.
- Pickets splitting at the nail line. This is thermal expansion. Los Angeles heat cycles, especially in the Valley and Inland areas, cause wood pickets to expand and contract. Nails don’t flex; they shear the grain. The fix is usually a switch to ring-shank stainless fasteners or a full picket replacement.
- Rail ends pulling away from posts. The rail was toe-nailed or end-nailed instead of using a proper rail bracket or mortise. Once the connection fails, the whole section loses rigidity and you’ll see a visible bow between posts.
- Post lean after rain. Water pools at the base, the post absorbs it, and rot begins at the soil line. In Los Angeles, this shows up fast in low spots on the property or where sprinkler heads sit too close to the fence line.
- White or gray streaking on the bottom six inches of pickets. That’s efflorescence and early dry rot from ground contact or standing water. The damage is already inside the wood by the time you see it on the surface.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
For a full KraftMaid-style fence replacement in Los Angeles, you’re looking at $4,130 to $10,620 installed. The spread comes down to three things: linear footage, whether we’re reusing existing footings or pouring new concrete, and the material. Cedar runs toward the higher end; pressure-treated pine brings the lower number. Gate hardware, post bases, and any retaining board along the bottom edge are included in our written price.
Every estimate we give is a flat number in writing before any work starts. You’ll see the material cost, labor, and hardware separated line by line. That price does not move at the door. If we find a rotted footing or a termite-damaged post during demo, we stop, show you, and scope the change in writing before we touch it. No surprise invoices at the punch list.
The work itself carries the 365-Day Done Right Promise. If your fence fails inside that year, we come back and correct it at no charge. That’s a written guarantee, signed and in your hand when the job closes.
DIY or Call Us?
If you’ve got a single loose picket or a gate hinge that just needs new screws, you can handle that with a cordless drill and an hour on a Saturday. The danger ceiling is low on basic fence work. Where DIY goes wrong is post replacement and gate re-hanging. A post set out of plumb by half an inch becomes a gate that swings open on its own or won’t close by winter. And a post hole dug through a sprinkler line or shallow gas line in a Los Angeles yard becomes a much bigger invoice than the fence job.
We’re not going to talk you out of doing it yourself if you’ve got the tools and the measurements. But if you’re dealing with a leaning post, a sagging gate, or rot that’s spread across multiple pickets, call us at (903) 568-7222 and we’ll give you a straight number. That’s how Curtis Lane runs this part of Bradford Remodeling: straight number, real scope, no surprises at the punch list.
| Scope | Typical Los Angeles Installed Cost |
|---|---|
| Full fence replacement (pressure-treated pine) | $4,130 – $7,080 |
| Full fence replacement (cedar) | $5,900 – $10,620 |
| Gate replacement with new hardware | $945 – $2,360 |
| Single post reset with new concrete footing | $470 – $1,180 |
| Picket section replacement (per 8-ft section) | $295 – $825 |
FAQs
A properly built cedar or pressure-treated fence in Los Angeles lasts 15 to 20 years with basic sealing every few years. The weak point is almost always the post-to-footing connection and the bottom six inches of the pickets, not the framing itself.
Yes, in most cases we can replace individual posts, pickets, or gate hardware without pulling the whole fence. Repair work runs $295 to $1,180 depending on what’s failed. Call (903) 568-7222 and we’ll give you a written line-item price before any work starts.
Most Los Angeles fence replacements take two to three working days from demo to final walkthrough. Gate-only work is usually done in a half day. We leave the site clean and walk the fence line with you before we call it done.
We stock standard post dimensions, cedar and pine pickets, rail brackets, and gate hardware on our trucks, along with material specs for the other brands we work with regularly: Cambria, Silestone, and Kohler. If your fence needs a routed profile matched to an existing KraftMaid outdoor kitchen surround, we’ll measure on site and spec the correct replacement in writing.
No. The written price you sign is the price you pay unless we uncover a structural issue that requires a change order. And if that happens, we stop work, show you what we found, and get your signature on the new scope before we proceed. That’s The Garrison Standard Bradford Remodeling is held to.
Written by Curtis Lane, Owner, Bradford Remodeling at Bradford Remodeling, serving Los Angeles and nearby areas.
