Unilock Fence Installation Nationwide

Unilock Fence Installation: The Los Angeles Owner’s Guide

Unilock fence installation in Los Angeles typically runs $4,130 to $10,620 for a complete fence line, installed. The spread depends on linear footage, panel style (Estate Wall, Pisa, or Brussels Block), and what we find under the old fence. Oddly enough, most Los Angeles homeowners don’t discover their Unilock fence has failed until a section starts leaning after a hard rain or a post top pops off. You’ll see cracked coping, a gate that drags on the paver base, or a stackstone column that’s pulled away from the wall panel. That’s when we get the call.

Call (903) 568-7222

Which Unilock Models This Applies To

We install and repair fence systems built on Unilock’s structural retaining and freestanding wall units. The ones we see most in Los Angeles backyards are the Estate Wall, Pisa, and Brussels Dimensional systems, plus matching Unilock caps and coping. Unilock panels are modular, but the gotcha is that each series has its own lip channel and cap profile. A Pisa cap will not seat correctly on an Estate Wall block, even if both are nominally the same width. If you still have a pallet tag or the original design sketch, that tells us the series and the batch dimensions. We work with OEM Unilock units when we can, and quality concrete aftermarket caps and adhesive when the series is discontinued. Bradford Remodeling is an independent contractor, not a Unilock dealer, which means we can tell you straight when an aftermarket cap is a fine substitute and when it isn’t.

Signs Your Unilock Fence Installation Is Failing

• Leaning wall panel with no visible crack: The drainage gravel behind the wall has washed out or was never placed. Unilock walls lean when the base course settles, not when the blocks fail. In Los Angeles clay soil, this is the most common failure we see after two or three winters.
• Cracking along the cap line: The capstone adhesive has failed and the cap has shifted, or the wall is moving at the cold joint between the setback course and the coping. If the cap crack is wider than a quarter inch, the problem is structural, not cosmetic.
• Gate dragging or latch not aligning: The gate post column has moved. Unilock gates usually hang on a concrete-filled column core; if the column core wasn’t poured, the post moves with every swing cycle. A drag mark on the paver base tells us the column is twisting.
• Efflorescence that won’t brush off: White chalky deposits on Unilock units are minerals leaching out of the concrete. It’s usually cosmetic, but if it keeps coming back after cleaning, water is soaking through the wall and taking cement paste with it. That’s a drainage issue, not a staining issue.
• Blocks separating at the top course: The wall is leaning outward and the coping is separating from the panel below. This almost always means the geo-grid was skipped or insufficient for the retained height. On a five-to-six-foot fence section, that’s a rebuild, not a patch.

Replacement Cost & What’s Included

For a Los Angeles Unilock fence installation or rebuild, expect $4,130 at the low end for a short straight run with clean access, up to $10,620 for a full perimeter fence with a gate, columns, and drainage rework. The middle of that range, around $6,500 to $7,500, is a typical 50-to-70-foot project with one gate and one angled corner. We write the line items: demolition and disposal of the old wall, base course gravel, Unilock units and caps, adhesive, column concrete, gate hardware, and labor. Tape, shims, and cleanup don’t show up as a surprise. The 365-Day Done Right Promise covers the installation in writing: if the wall shifts, cracks, or fails inside the warranty window, we come back and correct it at no charge. That’s The Garrison Standard, and it’s in the written agreement before we start.

DIY or Call Us?

You can check drainage outlets, clean the cap line, and watch for new cracks, but leave the tear-down to a pro. Unilock walls are deceptively heavy: a single Estate Wall unit runs 70 to 90 pounds, and pulling the wrong block first can drop a course on your foot. The real hazard in Los Angeles is what’s buried behind the wall. We’ve found old gas lines, abandoned electrical conduit, and more irrigation pipe than anyone remembers burying. If you have a leaning panel, we’ll scope it and tell you whether it’s a re-stack or a full rebuild. Call (903) 568-7222 and we’ll schedule a site visit, get you a written number, and tell you exactly what’s behind the wall before we touch it.

Key Takeaways

• Installed cost in Los Angeles: $4,130 to $10,620, depending on footage, panels, gates, and what’s underneath.
• What fails first: drainage and cap adhesive, not the Unilock blocks themselves.
• Written price before we start: every job, no exceptions. The Garrison Standard puts it on paper.
• 365-Day Done Right Promise: if the fence fails inside a year, we return and fix it at no charge.
• Straight number, real scope, no surprises at the punch list.

Whether you’re patching one leaning section or replacing a full perimeter fence, we’ll give you a written scope, a flat number, and a timeline we actually stand behind. We also work with KraftMaid, Cambria, and Silestone on interior projects across Los Angeles, but today’s your fence. Curtis Lane runs Bradford Remodeling with one rule: if it’s not in writing, it doesn’t count. Call (903) 568-7222 and we’ll get it in writing.

Written by Curtis Lane, Owner, Bradford Remodeling at Bradford Remodeling, serving Los Angeles and nearby areas.