Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Mr-Glass Kitchen Remodeling: The Los Angeles Owner’s Guide
We install and service Mr-Glass-compatible kitchen remodeling throughout Los Angeles, with most full kitchen remodels running between $16,520 and $53,100 depending on cabinet count, countertop material, and whether we’re moving plumbing or electrical. We’re an independent contractor, not affiliated with Mr-Glass directly, but our crews work with Mr-Glass components regularly and know where they hold up and where they fail. Most Los Angeles homeowners call us because a Mr-Glass cabinet hinge has stripped out, a glass panel insert has loosened, or the countertop seam has opened after a few hot summers. The call usually starts with “it worked fine for years,” and within ten minutes on the phone we’ve got a realistic fix-or-replace number for them.
Which Mr-Glass Models This Applies To
Mr-Glass kitchen components fall into two broad categories: the glass-front cabinet lines and the solid-surface countertop runs. On the cabinet side, Mr-Glass uses a European-style concealed hinge with a 35mm cup bore, which matters because a standard American 1-3/8″ overlay hinge will not fit without redrilling the door. If you open a cabinet door and see a small round recess on the back of the door, that’s the 35mm cup. On countertops, Mr-Glass fabricates to a standard 3cm edge profile in most Los Angeles homes, though we’ve seen older kitchens with 2cm material that requires a different sink clip and bracket set. The compatibility gotcha most owners miss: Mr-Glass glass-door cabinets from before 2015 use a different hinge mounting plate than post-2015 models. Take a photo of the hinge before ordering anything. We stock OEM-spec replacements and quality aftermarket equivalents on the truck, and we’ll tell you honestly when the aftermarket part is actually better made than the original.
Styles & brands we work with
Signs Your Mr-Glass Kitchen Remodeling Is Failing
- Cabinet door sag at the hinge. The hinge cup has worn or the mounting plate has loosened from the cabinet box. You’ll see the door rub against the frame at the top corner and the gap widen at the bottom. Los Angeles humidity swings between marine layer mornings and dry Santa Ana afternoons, and that cycle will eventually strip the particleboard screws holding the plate.
- Glass panel rattle inside an aluminum frame. The rubber gasket has dried and shrunk. On Mr-Glass doors, this is the first thing to fail in kitchens with south-facing windows, because UV exposure kills the gasket years before the glass itself has any issue.
- Countertop seam that catches a fingernail. The seam adhesive has degraded, usually from heat cycling near a range or a dishwasher vent. We see this most often in Los Angeles homes where the kitchen gets direct afternoon sun for three or four hours a day.
- Soft-close mechanism gone dead. The cylinder inside the hinge has lost its fluid charge. It’s a cheap part to swap, but if you ignore it, the door starts slamming and the hinge cup flexes, which then ovalizes the bore and turns a $15 part into a door replacement.
- Drawer slide binding or sticking. The ball bearings have picked up construction dust or cooking grease and the slide no longer travels clean. Left alone, the slide will eventually bend or pull the mounting screws out of the drawer box side.
Replacement Cost & What’s Included
Here’s what Mr-Glass kitchen remodeling work actually costs in Los Angeles, fully installed:
| Scope of Work | Installed Price Range |
|---|---|
| Full kitchen remodel (Mr-Glass compatible) | $16,520 – $53,100 |
| Small kitchen remodel | $10,620 – $23,600 |
| Cabinet installation only | $4,720 – $15,340 |
| Countertop installation | $2,360 – $7,670 |
| Backsplash installation | $945 – $2,950 |
| Kitchen island installation | $3,540 – $11,800 |
The range comes down to three things: whether existing cabinet boxes are sound enough to reuse, what countertop material you’re putting down, and whether plumbing or electrical needs to move. We write the price before any work starts. That written number covers the parts, the labor, the haul-away, and the cleanup. If it doesn’t say it on the scope, it doesn’t cost you anything. We stock Mr-Glass-compatible hinges, slides, gaskets, and seam kits on the truck in Los Angeles, which means most parts-only calls are one trip, not a diagnosis trip plus a second visit. Every job carries our 365-Day Done Right Promise: if the part we install or the seam we set fails within a year, we come back and make it right at no charge. That’s in writing, per The Garrison Standard.
See the difference
Before
After
Before
After
Before
AfterDIY or Call Us?
Some things you can check safely. Tighten a loose hinge mounting screw with a #2 Phillips, but if it spins without grabbing, the hole is stripped and forcing it will only chew more wood out. You can vacuum the ball bearings on a drawer slide and apply a dry lubricant, but don’t use WD-40 in a kitchen with food prep, it’ll attract dust and gum the slide up worse. Countertop seams and gas-line-adjacent work are not DIY territory. The seam adhesive we use is a two-part color-matched polyester that needs a 60-minute window and a vacuum jig to pull the two slabs tight enough to make the seam disappear. And anything involving a cooktop, a sink drain, or a gas line behind Mr-Glass cabinetry should be left to a licensed professional. If you’ve checked what you can check and it’s still not right, call (903) 568-7222. Curtis Lane and the Bradford Remodeling crew will give you a straight number on the phone, not a “we’ll have to send someone out and see.”
FAQs
Mr-Glass cabinet hardware in a Los Angeles kitchen typically lasts 10 to 15 years before hinges show wear, assuming the cabinets were installed level and the doors weren’t forced. The glass and aluminum frames themselves will outlast the hardware, but the rubber gaskets are a 7-to-10-year item in kitchens with strong UV exposure. If your kitchen gets direct afternoon sun through a window or slider, expect to replace gaskets roughly twice for every once a shaded kitchen would. Call (903) 568-7222 for an exact assessment, estimates are free.
Yes, in most cases. A stripped hinge screw hole can be repaired with a properly sized dowel and redrilled to spec, and a noisy slide can sometimes be rebuilt with a bearing kit rather than a full replacement. Repair makes sense when the surrounding structure is fundamentally sound. When the door has warped or the drawer box sides have split, replacement is cheaper than trying to save what’s left. We’ll tell you which one applies before you spend a dollar, and that answer is part of the free estimate.
A hinge or slide swap on a standard Los Angeles kitchen takes one to two hours on site, and we carry the parts on the truck. A full set of gasket replacements across twelve to fifteen cabinet doors takes about three to four hours. A countertop seam repair takes about half a day because the adhesive needs a full cure before the clamps come off. Call (903) 568-7222 and we’ll give you a time window, not a “sometime Thursday.”
We stock OEM-spec Mr-Glass-compatible hinges, mounting plates, gaskets, slides, and seam kits on the truck in Los Angeles, along with compatible parts for KraftMaid, Cambria, and Silestone kitchens. For less common parts, we order direct from our supplier network and have them staged for your install date. You never have to source your own parts on a Bradford Remodeling job, because a written scope that relies on the homeowner buying the right thing is not a scope we’ll sign. One call to (903) 568-7222 covers the part, the price, and the day we show up.
Ready to Get It Fixed?
Straight number, real scope, no surprises at the punch list. That’s how Curtis Lane runs Bradford Remodeling, and it’s the same standard we’ve held across Los Angeles since joining the Garrison Partners family in 2004. If your Mr-Glass kitchen is failing, call (903) 568-7222. A live person answers, we’ll talk through what you’re seeing, and we’ll give you a written price before any work starts. Estimates are free.
Written by Curtis Lane, Owner, Bradford Remodeling at Bradford Remodeling, serving Los Angeles and nearby areas.
